rolling resistance was adequately low but could be lowered further. I think I want to build some wheel having investigated this topic as part of the project and as a commuter cyclist who always wants to go faster.
I need to rethink blades to better capture wind. The vinyl on spokes approach is better than the saran wrap I tried but hardly a resounding success. Comments bellow on other approaches would be appreciated. Current improvement that occurs to me is tacking pre cut blades sheet metal to the spokes.
The weld fit up /tacking was challenging. If I were to repeat might jig. Might notch where I cut off fork tine to improve fit.
Finish of vinyl was good but could have been perhaps better. I had never applied vinyl before and getting it to stick to curved/uneven surfaces was very challenging. I didn’t mind that there was some cracking/bubble lines but probably not the cleanest aesthetic. Might sandblast and powder coat next time to create a more even finish.
Overall was fun and interesting getting used parts and turning into a budding piece of sculpture for a new sculpture artist. Hope you enjoyed!